Idec DATAVS2 Series Manuel d'utilisateur télécharger pdf (Page 12)

SVS2 Series Instruction Manual

If you use a direct connection:

• From menu START select Control Panel Network Connections  LAN Conncetion;

• Press the right mouse button and select Properties;

• Select Internet Protocol (TCP/IP) then click the Properties button (as shown below);

• Select Use the following IP Address option;

• Enter the following:

IP ADDRESS: 172.27.101.1;

SUBNET MASK: 255.255.0.0;

Note: no entries for Default Gateway or Use the following DNS Server Address are necessari.

• Click OK to close the dialog TCP/IP properties; then click OK at the LAN Properties dialog.

If you are connected to the sensor through a routing device you should first verify if the network hosts

a DHCP server.

• If the network hosts a DHCP Server

o From menu START select Control Panel  Network Connections  LAN Connections;

o Press the right mouse button and select Properties;

o Select Internet Protocol (TCP/IP) then click Properties button again;

o Finally select Obtain an IP Address automatically.

• If the network doesn’t host a DHCP Server:

o Please contact your local IT manager for assigning an IP Address toyour PC;

o Follow the instructions for direct connection configuration (pag. 8).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 82 83

Pas de commentaire

Idec DATAVS2 Series Manuel d'utilisateur Page 12